Hello folks,
Looking for guidance for replacing/fabricating a new entry door for our Breakaway XL(front entry). The original door has a wooden core that has absorbed moisture over the years which has caused the aluminum skin(exterior) to oxidize. Door is full of holes, and the bottom has completely separated from the frame. This door has never fit the opening very well which creates a lot of wind noise when traveling down the road. I think it might have gotten distorted from being slammed open by the wind at some point with a PO. Looking for leads on a fabrication shop primarily, or as a last result, I could attempt at fabricating another, but again would prefer having a shop do the work. I am located outside the Chattanooga TN area.
Any info would be appreciated.

Check this thread for some do-it-yourself magic:

https://www.barthmobile.com/eve...573955787#9573955787

MichaleR, There is a Barth Door listed here on Craigslist with measurements.

Thanks guys.

Michael