Forums    General Discussions    Acceleration
Go to...
Start A New Topic
Search
Notify
Tools
Reply To This Topic
  
Acceleration
 Login now/Join our community
 
Supporting Member of Barthmobile.com 11/12
Picture of Nick Cagle
posted
I received the following from a drag racer friend of mine. I can't verify any of the numbers but I thought some of the more mechanically minded members might get a kick out of the comparisons here.

Nick


'DEFINITION OF ACCELERATION'

One top fuel dragster 500 cubic inch Hemi engine makes more horsepower
than the first 4 rows of stock cars at the Daytona 500.

It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA
Top Fuel dragster engine to reach the rear wheels.

Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro
methane per second; a fully loaded 747 consumes jet fuel at the same rate
with 25% less energy being produced.

A stock Dodge Hemi V8 engine cannot produce enough power to drive the
dragster's supercharger.

With 3,000 CFM of air being rammed in by the supercharger on overdrive,
the fuel mixture is compressed into a near-solid form before ignition.

Cylinders run on the verge of hydraulic lock at full throttle.

At the stoichiometric (stoichiometry: methodology and technology by
which quantities of reactants and products in chemical reactions are
determined) 1.7:1 air/fuel mixture of nitro methane, the flame front
temperature measures 7,050 deg F.

Nitro methane burns yellow. The spectacular white flame seen above the
stacks at night is raw burning hydrogen, dissociated from atmospheric water
vapor by the searing exhaust gases.

Dual magnetos supply 44 amps to each spark plug. This is the output of
an arc welder in each cylinder.

Spark plug electrodes are totally consumed during a pass. After
halfway, the engine is dieseling from compression, plus the glow of exhaust
valves at 1,400 deg F. The engine can only be shut down by cutting the fuel
flow.

If spark momentarily fails early in the run, unburned nitro builds up in
the affected cylinders and then explodes with sufficient force to blow
cylinder heads off the block in pieces or split the block in half.

In order to exceed 300 mph in 4. 5 seconds, dragsters must accelerate an
average of over 4G's. In order to reach 200 mph (well before half-track),
the launch acceleration approaches 8G's.

Dragsters reach over 300 miles per hour before you have completed
reading this sentence.

Top fuel engines turn approximately 540 revolutions from light to light!
Including the burnout, the engine must only survive 900 revolutions under
load.

The redline is actually quite high at 9,500 rpm.

Assuming all the equipment is paid off, the crew worked for free, and
for once NOTHING B LOWS UP, each run costs an estimate $1,000.00 per second.

The current top fuel dragster elapsed time record is 4.428 seconds for
the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ). The top speed
record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony
Schumacher, at Hebron , OH ).

Putting all of this into perspective:

You are driving the average $140,000 Lingenfelter 'twin-turbo' powered
Corvette Z06. Over a mile up the road, a top fuel dragster is staged and
ready to launch down a quarter mile strip as you pass. You have the
advantage of a flying start. You run the 'Vette hard up through the gears
and blast across the starting line and pass the dragster at an honest 200
mph. The 'tree' goes green for both of you at that moment.

The dragster launches and starts after you. You keep your foot down
hard, but you hear an incredibly brutal whine that sears your eardrums and
within 3 seconds, the dragster catches and passes you. He beats you to the
finish line, a quarter mile away from where you just passed him.

Think about it, from a standing start, the dragster had spotted you 200
mph and not only caught, but nearly blasted you off the road when he passed
you within a mere 1,320 foot long race course.

... and that my friend, is ACCELERATION!
 
Posts: 1732 | Location: Harlem, GA | Member Since: 09-17-2007Reply With QuoteReport This Post
Supporting Member of Barthmobile.com 10/10
Picture of roman
posted Hide Post
Well done Nick. I don't follow racing but the numbers and the comparisons you provided are quite interesting. I'm sure the guys at coffee break will enjoy them too as some of them are big time NASCAR fans.

Ron


1993, 34', Regency, Widebody
300 HP Cummins
6 spd Allison, Spartan Chassis
 
Posts: 73 | Location: Alaska | Member Since: 03-08-2009Reply With QuoteReport This Post
First Month Member
Supporting Member of Barthmobile.com 11/13
posted Hide Post
quote:
Originally posted by Nick Cagle:

You are driving the average $140,000 Lingenfelter 'twin-turbo' powered
Corvette Z06. .............Think about it, from a standing start, the dragster had spotted you 200
mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course.



OK..........I am terminating contributions to my Lingenfelter fund. Gonna put it in my Barth instead.

Thanks for busting my bubble. Frowner


.

84 30T PeeThirty-Something, 502 powered
 
Posts: 6169 | Location: AZ Central Highlands | Member Since: 01-09-2001Reply With QuoteReport This Post
FKA: noble97monarch
Supporting Member of Barthmobile.com 3/12
Picture of Moonbeam-Express
posted Hide Post
One of the fun perks of my job is that once a year I get to hang out with Tony Schumacher (The Sarge) and his crew chief at the Army's annual event in DC (he drives the Army TF Dragster). Being a gear-head from way back, I've quizzed them up and down about the top fuel cars and techniques and I recall these amazing facts in addition to your awesome list.

Q: I asked how many runs they get out of a set of slicks. A: one run if it's a good hook up. Reason: the wheels spin 3 times more revolutions than if you simply rolled the car down the track. They are essentially "laying down" all the rubber the tire has to give in a perfect hook up!

Q: I asked how they can do a complete rebuild of an engine outdoors in a dusty/dirty environment? When ever I've done engine work it was critical to keep every piece of dust/dirt from contaminating the rebuild. A: You want to get 100,000 miles out of your engine, we need to get 1/4 mile! Furthermore, when a top fuel engine is at full throttle, a small bird could fly through it without hitting anything (metaphorically as the bird would be cooked naturally).

Q: How do you steer the car at 300 MPH with skinny little tires that are hardly touching the ground? A: Those tires are used more like rudders in the air.

I also asked about the transmission (of sorts) in the car. Essentially there are mechanical weights that throw clutches to the next gear. It is interesting that in this day and age that this is still a simple mechanical device.

One final tidbit for the next time you watch a drag race, there are two fuel pumps - one for the burnout and a second one is engaged for the run. You can actually hear the second one kick in on TV when watching a race. As there is no coolant in these "motors", staging and launch must happen relatively quickly or disaster can occur.

Anyway, fun stuff!

Corey




Formerly: 1997 Barth Monarch
Now: 2000 BlueBird Wanderlodge 43' LXi Millennium Edition DD Series 60 500HP 3 stage Jake, Overbuilt bike lift with R1200GS BMW, followed by 2011 Jeep Wrangler Unlimited,
“I haven’t been everywhere, but it’s on my list.”
 
Posts: 2228 | Location: Laurel Park, NC | Member Since: 03-16-2008Reply With QuoteReport This Post
"Host" of Barthmobile.com
Supporting Member of Barthmobile.com 1/19
Picture of Bill N.Y.
posted Hide Post
quote:
Originally posted by noble97monarch:
As there is no coolant in these "motors", staging and launch must happen relatively quickly or disaster can occur.
From what I understand, it's just filled with sand or cement.


˙ʎ˙u ןןıq- „ǝןƃuɐ ʇuǝɹǝɟɟıp ɐ ɯoɹɟ pןɹoʍ ǝɥʇ ʇɐ ʞooן ɐ ƃuıʞɐʇ sı ǝɟıן oʇ ʇǝɹɔǝs ǝɥʇ„

Regis Widebody1990 Barth Regis Widebody
8908 0128 40RDS-C1
L-10 Cummins
Allison MT647 Transmission
Spartan Chassis
Regal Conversion1991 Medical Lab Conversion
9102 3709 33S-12
Ford 460 MPFI
C6 Transmission
Oshkosh Chassis



Quick Link: Members Only Link To Send Me A Private Message
 
Posts: 5924 | Location: Newburgh, New York | Member Since: 05-10-2003Reply With QuoteReport This Post
First Month Member
Supporting Member of Barthmobile.com 11/13
posted Hide Post
quote:
Originally posted by Bill N.Y.:
quote:
Originally posted by noble97monarch:
As there is no coolant in these "motors", staging and launch must happen relatively quickly or disaster can occur.
From what I understand, it's just filled with sand or cement.


I poured a concrete/ceramic mix in the lower water jacket of a boat engine to reinforce the lower block due to extreme overbore. I think I got it from Traco.


.

84 30T PeeThirty-Something, 502 powered
 
Posts: 6169 | Location: AZ Central Highlands | Member Since: 01-09-2001Reply With QuoteReport This Post
  Powered by Social Strata  
 

    Forums    General Discussions    Acceleration

This website is dedicated to the Barth Custom Coach, their owners and those who admire this American made, quality crafted, motor coach.
We are committed to the history, preservation and restoration of the Barth Custom Coach.