I have removed the overhead bed in my 19' Barth. If anyones interested, let me know. I will send or try to post pictures if there is any interest.
I am located in Agassiz in the upper Fraser Valley in British Columbia.

Thanks!! Read

I'd be interested if it's something you'd be willing to ship, at my expense of course. I don't think I'd need the bed frame itself shipped because it would probably be easy enough to fabricate one at my end.

I'm leaving tomorrow morning for MA where I'm jumping on a boat and heading down the intercoastal, so my internet access will probably be limited. If you'd like to talk to me directly you can contact me at 773.727.6725

Thanks,
Andy

Did you sell this yet?

Hi..sorry for the delay.

I haven't sold the bed yet, but I don't think it would be practical to ship the components.

I'm compiling a list of the components and some weights. Basically there are two side "scissor" plates. An aluminum framed bed surface with special ends, and a full width aluminum/wood side to side cross member with some pulleys and rubber tie straps attached.

It wasn't actually functioning when I bought the Barth. The fellow I bought it from said it was working when he got it so...

Hope this helps..Read

I have the same motorhome. I'd like to see a pic of any aditional bedding, the small one behind drive and dinette make me want a bigger unit.

I'm in Victoria BC and have a 22' Barth. I'd love to see some pictures of this.