Start A New Topic
Reply To This Topic
I have put together a list of wire numbers/terminal board numbers/etc. and sorted it in various ways. I have attached it. I don't know if it will be of any help. It may get some additional editing in the near future but I can post it again.
1993 Barth 38' Regency Wiring Pt1 - (26 KB) ~ Wire List for 1993 Regency
Lance & Sue Walton
1993 38ft Regency
Cummins 6CTA8.3 300HP
Allison MD3060 Transmission
Your list is great! I have downloaded it but wonder if you can tell me where each of the TB's are and how to recognize them?
1993 32' Regency Wide Body, 4 speed Allison Trans, Front Entry door, Diamond Plate aluminum roof &
1981 Euro 22' w Chevy 350 engine and TH 400 tranny
Hey Lance - your wiring printout is great. Ours is a 1994 Breakaway, but should be similar. I have the same problem as Tom - nothing is marked or labeled and need to understand where the Terminal boards are and how to identify each one?
94 33 Foot Breakaway Widebody
9310-3888-33XG-7C Front Entry
8.3 Cummins Banks 3060 Allison
As the discussion has often indicated, no two are alike, but I had thought that the wiring in our 1993 Breakaway was just the standard.
Our wiring is ALL labeled and numbered--- am not sure if the numbering is from end to end of the wire, but in the electrical compartment all are numbered and labeled! !
1993 Breakaway 36ft & 1977 20 ft
Spartan: air ride and brakes & P32(?)
Cummins: 8.3 litre 250hp, PACBrake
Allison 3060 (6 spd)
Front entry, side hallway
7.5 kw diesel gen.
1999 2dr Tracker 4X4 5spd, SMI Braking system
Bud, my Breakaway is same as yours. All wires are white and each has a number and and ID as to what it is for. The labeling goes the full length of each wire. Most wires are very easy to trace along their path. I have some wires that I can not find the other end.
Example: I have a "trans temp" labeled wire at the instrument panel but the transmission has no temp sender. I even looked at the ECU for the transmission but found nothing.
94 30' Breakaway #3864
30-BS-6B side entry
230 Cummins, Allison 6 speed
Wrench is right-on. I have a 93 breakaway routing diagram, (not just sure where as I am in gv,az and the Barth is still in Ticaboo, Ut but will look for it and scan it. it is a little hard to follow but after a while you can even figure out where the "spare" wires are. will bookmark this page and be back in a few days, john
|Powered by Social Strata|