Screen Removal Bargman L-300 Door Handle brakes Satellite Fuel Tank Fire Extinguishers Roof Antenna Tech Talk Forum Shortcut Motor Oil Window Generators headlights batteries Radiator AC Unit Grab Handle Wiper Blades Wiper Blades Door Locks Door Locks Door Locks Door Locks Rims Front Shocks Rear Shocks Front Tires Oil Filter Steps Roof Vent Awning Propane Tank Mirror Info Clearance Lights Clearance Lights Clearance Lights Clearance Lights Clearance Lights Spartan Chassis Gillig Chassis Freightliner Chassis P-32 Chassis MCC Chassis
    Forums    Tech Talk    Battery Maintenance Charging
Go to...
Start A New Topic
Search
Notify
Tools
Reply To This Topic
  
Battery Maintenance Charging
 Login now/Join our community
 
Supporting Member of Barthmobile.com 1/21
Picture of Pirate19
posted
Pittsburgh...BRRRR. (-3 actual, 25 mph = -25 feel tonight)
Have two domestic side deep cell batteries and two chassis batteries. Each battery set is separated via a latch disconnect, and therefore each of the four batteries is charged separately.
Question: With battery integrity/preservation being the primary objective, at what battery voltage reading (using a multi-meter) is charging recommended? And should they be charged at 2 amp or 10 amp? (Battery "maintainer" is not an option.)


'92 Breakaway
Cummins 190hp, No Modifications
Allison AT542
Floor Plan 30-BS-11B
9205-3798-30BS11B
 
Posts: 384 | Location: USA | Member Since: 11-07-2014Reply With QuoteReport This Post
Supporting Member of Barthmobile.com 8/19
posted Hide Post
Ted, I am not sure about the correct answers to your questions. There are electrical guru members here that can better answer your questions.
Here is something you may like. Santa, (my oldest brother) stuffed this Stanley Charger into my stocking. So far I like the reconditioning feature. I resurrected two batteries. I keep batteries on my bench to test stuff. This charger has an alternator check mode also.
 
Posts: 2478 | Location: Ohio | Member Since: 07-29-2012Reply With QuoteReport This Post
Supporting Member of Barthmobile.com 1/21
Picture of Pirate19
posted Hide Post
Thanks Kevin. Will consider. Have a lot of "out of season" equipment and vehicles with batteries that require on going attention. I once had a battery overcharge on a charger's maintenance mode. I noticed the side casing distorted outward!

My juvenile understanding of batteries is that the voltage is created from the chemical reaction between the lead and hydrochloric acid. And that it is this electrical charge in the lead plates that minimalizes the acid from eroding the plates. (Eventually the acid wins - the plates erode to the point where the fallen lead particulates create an electrical short between a couple plates, and the battery life ends.) In addition, battery life can be shortened by the build up of sulfate on the plates surfaces. This build up occurs during charging and can be reduced via the maintenance mode on the charger.

My question deals with the first mentioned cause - plate disintegration. A fully charged battery should carry about 12.5V, correct? How much lower does the voltage need to get to resulting in the plates being less protected?

Incidentally, regarding the sulfate: I read somewhere that to reduce the build up while charging the battery casing can be lightly tapped (wood block and small hammer}. Any truth?


'92 Breakaway
Cummins 190hp, No Modifications
Allison AT542
Floor Plan 30-BS-11B
9205-3798-30BS11B
 
Posts: 384 | Location: USA | Member Since: 11-07-2014Reply With QuoteReport This Post
Supporting Member of Barthmobile.com 6/12
Formally known as "Humbojb"
Picture of Jim and Tere
posted Hide Post
I installed a Progressive Dynamics Power Converter with Intellicharger in Old Blue shortly after I got her in 2005. The 4 Optima AGM batteries were a few years old at the time. Tere also installed a battery separator system around 2013. Roger Pense replaced the batteries last year. They lasted about 15 years.

Jim


Jim and TereJim and Tere

1985 Regal
29' Chevy 454 P32
8411 3172 29FP3B
Gear Vendor 6 Speed Tranny
 
Posts: 3696 | Location: madisonville tn usa | Member Since: 02-19-2005Reply With QuoteReport This Post
Official Barth Junkie
Supporting Member of Barthmobile.com 1/24
Picture of Steve VW
posted Hide Post
My Regal has had a Progressive Dynamics charger on for 6 years. Never had to add water once, batteries always topped off. Good unit, not sure what the final float voltage is.


9708-M0037-37MM-01
"98" Monarch 37
Spartan MM, 6 spd Allison
Cummins 8.3 325+ hp
 
Posts: 5168 | Location: Kalkaska, MI | Member Since: 02-04-2011Reply With QuoteReport This Post
  Powered by Social Strata  
 

    Forums    Tech Talk    Battery Maintenance Charging

This website is dedicated to the Barth Custom Coach, their owners and those who admire this American made, quality crafted, motor coach.
We are committed to the history, preservation and restoration of the Barth Custom Coach.