Start A New Topic
Reply To This Topic
I have a 1972 Barth Continental 25-C. The Vehicle ID is CPE372J104390. I believe it is a P37 chassis. It has a Chevy 350 engine and Turbo 400 tranny. I need brake parts and U joints. Where do you get your parts? Do you refer to the Barth as a P37 RV chassis? I'm new to the RV world. Thanks for any advice/ help!
When calling parts stores they only list a P30 chassis, and from what I can tell from the forums this is not the same as the P37. Is that right? If P30 parts don't fit a P37 chassis, Where do I get parts?
I'm new to this madness , thanks for any help.
There is much discussion here on the site about the P3X variants. Many of the parts are the same. Suspensions are similar. If you can find the GM chassis tag it may still have RPO codes. These identified option packages right from the factory.
Brakes will vary. Depending on chassis load rating there will be either rear drums or disk brakes. Measure diameters and number of lugs to help id the parts.
As for ujoints, with trans and axle ends known they should be able to find them. You will likely have a Turbo-Hydramatic trans and a Dana axle.
good luck. If you find parts that work let us know the numbers so we can share with others.
86 Regal SE 33 Tag axle--"98" Monarch 37
Chev P3(7) 454TBI--------Spartan MM, 6 spd Allison
400 hp fuel injected-------Cummins 8.3 300 hp
|Powered by Social Strata|