Start A New Topic
Reply To This Topic
First off hello to all! I'm a new Barth owner and I am sure will have a lot of questions along the way, however what I have going on now is that I need to install a trailer brake controller. The specs. on this coach is already on this site from the previous owner Richard Muise. I did get a lot of manuals with this thing but sometimes advice from someone who's done it before is invaluable. An and all advice is appreciated. Data tag #9309
Welcome to the site and the group. Richard took good care of his coach. You should be all set. I have not hooked up a brake control in 40 years so I will defer to someone with more current knowledge.
Dana & Lynn
1997 38ft Monarch front entry
Spartan Mountain Master Chassis
Cummins 8.3 325hp
Allison MD-3060 6 speed
Cummins Factory Exhaust Brake
Christened Camp Barth
Welcome to Barthmobile. I know Richard's coach and it was well cared for. Use only an inertia controller for electric brake controller, do not skimp on cost, get a good one. I installed a Primus by Tekonsha, used it for over 100,000 miles worked well in a dual axle trailer. This installation is on a 30' Breakaway.
Enjoy see ya around!
94 30' Breakaway #3864
30-BS-6B side entry
230 Cummins, Allison 6 speed
Hi, I’m Richard Muise. I owned your coach for over 15 years. If you have any questions about it, feel free to get in touch with me. 413-330-7112.
R.P.Muise 1994 Breakaway/Cummins 5.9/Allison transmission/Spartan Chassis
Thank you all for the information, I have found a controller I like and am moving forward with the install. Richard, thanks for reaching out. I will be calling you in the near future I have a few specific questions on this coach. Thanks
|Powered by Social Strata|